Stiebel-eltron HDB-E Si 01.11.2012 - 31.01.2013 User Manual download pdf (Page 20)

20 | HDB-E Si www.stiebel-eltron.com

INSTALLATION

Installation

Flexible water connection lines

f If the appliance is installed with ﬂexible water connection

lines, ensure that the pipe bends do not become twisted.

Pipe bends have a bayonet ﬁtting and are installed inside the

appliance.

f Secure the back panel at the bottom with an additional

screw.

9.1 Installation site

Material damage

Install the appliance in a room free from the risk of frost.

f Always install the appliance vertically near the draw-off

point.

The appliance is suitable for undersink and oversink installations.

Note

The appliance must be ﬁtted to a wall with sufﬁcient

load-bearing capacity.

Undersink installation

26_02_02_1373

1 Cold water inlet

2 DHW outlet

Oversink installation

26_02_02_1374

1 Cold water inlet

2 DHW outlet

9.2 Factory settings

The appliances are prepared in the delivered condition:

- Power supply from “below”, installation on unﬁnished walls

- Water connection, installation on unﬁnished walls

10. Installation

This chapter describes installation in accordance with the factory

settings.

For further installation options, see chapter “Installation alterna-

tives”.

26_02_02_1367

f Open the appliance.

26_02_02_1101

f Press the two locking hooks and remove the lower part of

the back panel towards the front.

26_02_02_0810_

f Mark out the holes to be drilled; see chapter “Speciﬁcation /

Dimensions and connections”.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 71 72

Comments to this Manuals

No comments

Stiebel-eltron HDB-E Si 01.11.2012 - 31.01.2013 User Manual Page 20

Comments to this Manuals

Related products and manuals for Water boiler Stiebel-eltron HDB-E Si 01.11.2012 - 31.01.2013